Page 1 of 1

Show mailing block-size and delay-time on SEND-TAB

PostPosted: Fri Apr 15, 2011 8:46 am
by Fatalin
Hi,

When sending a mailing you can choose the block-size and a delay-time between the blocks.
However, once you set those parameters and hit "send", you can not see the set parameters again.

It would be great if not only the date/time when the mailing will be send is shown, but the block-size and delay-time as well.

Thank you.

Best Regards
Markus

Re: Show mailing block-size and delay-time on SEND-TAB

PostPosted: Fri Apr 15, 2011 9:43 am
by maschoff
Where exactly should it be shown?

Re: Show mailing block-size and delay-time on SEND-TAB

PostPosted: Fri Apr 15, 2011 12:50 pm
by Fatalin
Hello Maschoff,

Thank you for the quick reply.

I believe it could be shown between the Production and Send time blocks.
Please see my below mockup as examlpe:

Image

Best Regards
Markus

Re: Show mailing block-size and delay-time on SEND-TAB

PostPosted: Fri Apr 22, 2011 9:24 am
by maschoff
Got it! However, next release OpenEMM 2011 has a complete new user interface. We will check how to integrate this into the new design.